Anritsu MS2840A - :CALCulate:MARKer[1]|2|3|4|5|6|7|8|9|10:X <freq>|<time>

Chapter 2 SCPI Device Message Details
2-112
:CALCulate:MARKer[1]|2|3|4|5|6|7|8|9|10:X <freq>|<time>
Zone Marker Frequency (Time)
Function
This command moves the center of the zone marker to the specified
frequency or time.
Command
:CALCulate:MARKer[n]:X <freq>|<time>
Parameter
<n>
Marker number
1
Marker 1
2
Marker 2
3
Marker 3
4
Marker 4
5
Marker 5
6
Marker 6
7
Marker 7
8
Marker 8
9
Marker 9
10
Marker 10
When omitted: Marker 1
<freq>
Center frequency of zone marker
Range
[MS269xA]
–100 MHz to 6.05 GHz (MS2690A)
–100 MHz to 13.6 GHz (MS2691A)
–100 MHz to 26.6 GHz (MS2692A)
[MS2830A]
–100 MHz to 3.7 GHz (Option 040)
–100 MHz to 6.1 GHz (Option 041)
–100 MHz to 13.6 GHz (Option 043)
–100 MHz to 26.6 GHz (Option 044)
–100 MHz to 43.1 GHz (Option 045)
[MS2840A]
–100 MHz to 3.7 GHz (Option 040)
–100 MHz to 6.1 GHz (Option 041)
–100 MHz to 26.6 GHz (Option 044)
–100 MHz to 44.6 GHz (Option 046)
Resolution 0.01 Hz
Suffix code HZ, KHZ, KZ, MHZ, MZ, GHZ, GZ
Hz is used when omitted.
Default X-axis center
<time> Center time of zone marker
Range –1000 to 1000 s
Resolution 1 ns
Suffix code NS, US, MS, S