Anritsu MS2840A - :CALCulate:MARKer[1]|2|3|4|5|6|7|8|9|10[:SET]:CENTer

2.4 Marker
2-137
2
SCPI Device Message Details
:CALCulate:MARKer[1]|2|3|4|5|6|7|8|9|10[:SET]:CENTer
Marker to Center Frequency
Function
This command sets the marker frequency to the center frequency.
Command
:CALCulate:MARKer[n][:SET]:CENTer
Parameter
<n>
Marker number
1
Marker 1
2
Marker 2
3
Marker 3
4
Marker 4
5
Marker 5
6
Marker 6
7
Marker 7
8
Marker 8
9
Marker 9
10
Marker 10
When omitted: Marker 1
Details
This command is not available in the following cases:
•
When the marker mode is set to Off.
•
During the Spurious Emission measurement.
•
During the Spectrum Emission Mask measurement.
Example of Use
To set the marker frequency to the center frequency.
CALC:MARK:CENT