Anritsu MS2840A - [:SENSe]:SEMask:OFFSet[1]:LIST:DETector <mode_1>[,<mode_2>[,<mode_3>[,<mode_4>[,<mode_5>[,<mode_6>[,<mode_7>[,<mode_8>[,<mode_9>[,<mode_10>[,<mode_11>[,<mode_12>]]]]]]]]]]]

Chapter 2 SCPI Device Message Details
2-634
[:SENSe]:SEMask:OFFSet[1]:LIST:DETector
<mode_1>[,<mode_2>[,<mode_3>[,<mode_4>[,<mode_5>[,<mode_6>[,<mo
de_7>[,<mode_8>[,<mode_9>[,<mode_10>[,<mode_11>[,<mode_12>]]]]]]]]]]]
Spectrum Emission Mask Offset Detection Mode
Function
This command selects the detection mode of the waveform pattern of the
offset for Spectrum Emission Mask measurement.
Command
[:SENSe]:SEMask:OFFSet[1]:LIST:DETector <mode_n>
Parameter
<mode_n>
Detection mode selection for Offset-n
NORMal
Simultaneous positive and negative peak
detection (Default)
POSitive
Positive peak detection
NEGative
Negative peak detection
SAMPle
Sample detection
RMS|AVERage
RMS detection
Example of Use
To set the detection mode of the offset.
SEM:OFFS:LIST:DET
POS,POS,POS,POS,POS,POS,POS,POS,POS,POS,POS,POS