Anritsu MS2840A - [:SENSe]:SEMask:BANDwidth[1]:VIDeo:AUTO?

2.13 Spectrum Emission Mask
2-611
2
SCPI Device Message Details
[:SENSe]:SEMask:BANDwidth[1]:VIDeo:AUTO?
Spectrum Emission Mask Video Bandwidth Auto/Manual Query
Function
This command queries the On/Off state of the automatic resolution
bandwidth (RBW) setting function when measuring the reference power
for Spectrum Emission Mask measurement.
Query
[:SENSe]:SEMask:BANDwidth[1]:VIDeo:AUTO?
Response
<switch>
Parameter
<switch>
Automatic resolution bandwidth setting On/Off
state
1
Automatic resolution bandwidth setting function
is enabled.
0
Automatic resolution bandwidth setting function
is disabled.
Details
This command is fixed to Auto and cannot be set, when Detection is set
to the following:
•
RMS
The setting range of this function is limited depending on the settings of
RBW. Refer to the
MS2690A/MS2691A/MS2692A Signal Analyzer
Operation Manual (Spectrum Analyzer Function Operation)
or
MS2830A/MS2840A Signal Analyzer Operation Manual (Spectrum
Analyzer Function Operation)
for details.
Example of Use
To query the On/Off state of the automatic video bandwidth setting
function when measuring the reference power.
SEM:BAND:VID:AUTO?
> 1