Anritsu MS2840A - :CALCulate:LLINe[1]|2|3|4|5|6:TYPE UPPer|LOWer

2.6 Trace
2-197
2
SCPI Device Message Details
:CALCulate:LLINe[1]|2|3|4|5|6:TYPE UPPer|LOWer
Limit Type
Function
This command sets the Limit Line type to either Upper Limit or Lower
Limit.
Command
:CALCulate:LLINe[1]|2|3|4|5|6:TYPE <mode>
Parameter
<mode>
Type of Limit Line
UPPer
Upper Limit (Default)
LOWer
Lower Limit
Details
References for judging Pass/Fail depend on the types: Upper and Lower.
When the type is Upper and the signal is below Limit Line, it is
determined as Pass.
When the type is Lower and the signal exceeds Limit Line, it is
determined as Pass.
Example of Use
To set a type for Limit Line to Lower.
CALC:LLIN:TYPE LOW