Anritsu MS2840A - :CALCulate:MARKer[1]|2|3|4|5|6|7|8|9|10:STATe OFF|ON|0|1

2.4 Marker
2-105
2
SCPI Device Message Details
:CALCulate:MARKer[1]|2|3|4|5|6|7|8|9|10:STATe OFF|ON|0|1
Marker State
Function
This command sets the marker to On/Off.
Command
:CALCulate:MARKer[n]:STATe <switch>
Parameter
<n>
Marker number
1
Marker 1
2
Marker 2
3
Marker 3
4
Marker 4
5
Marker 5
6
Marker 6
7
Marker 7
8
Marker 8
9
Marker 9
10
Marker 10
When omitted: Marker 1
<switch>
Marker mode
ON|1
Sets the marker mode to Normal.
OFF|0
Sets the marker mode to Off.
Details
This command is not available during Spurious Emission measurement
and when Displayed Segment Mode is Auto.
Not available during Spectrum Emission Mask measurement.
Example of Use
To set the marker 2 to Normal.
CALC:MARK2:STAT ON