Anritsu MS2840A - [:SENSe]:SWEep:EGATe:SLOPe?

Chapter 2 SCPI Device Message Details
2-298
[:SENSe]:SWEep:EGATe:SLOPe?
Gate Slope Query
Function
This command queries the detection mode for the gate signal.
Query
[:SENSe]:SWEep:EGATe:SLOPe?
Response
<mode>
Parameter
<mode>
Detection mode for gate signal
POS
Detects at the rising edge.
NEG
Detects at the falling edge.
Details
This setting is enabled when the gate signal source is wideband IF
detection (Wide IF Video), external input (External), SG marker, or
Baseband Interface (BBIF).
Example of Use
To query the detection mode for the gate signal.
SWE:GATE:SLOP?
> POS