Anritsu MS2840A - :DISPlay:SEMask:VIEW[1]:WINDow[1]:TRACe:Y[:SCALe]:PDIVision <rel_ampl>

Chapter 2 SCPI Device Message Details
2-692
:DISPlay:SEMask:VIEW[1]:WINDow[1]:TRACe:Y[:SCALe]:PDIVision
<rel_ampl>
Log Scale Range
Function
This command sets the Y-axis scale magnification when Scale Mode is
set to Log.
Command
DISPlay:SEMask:VIEW[1]:WINDow[1]:TRACe:Y[:SCALe]:PDIVisi
on <rel_ampl>
Parameter
<rel_ampl>
Y-axis scale magnification
0.1
0.1 dB/div
0.2
0.2 dB/div
0.5
0.5 dB/div
1
1 dB/div
2
2 dB/div
5
5 dB/div
10
10 dB/div
20
20 dB/div
Default 10 dB/div
Example of Use
To set the scale range to 0.5 dB/div.
DISP:SEM:VIEW:WIND:TRAC:Y:PDIV 0.5
Related command
This command has the same function as the following commands.
:DISPlay:WINDow[1]:TRACe:Y[:SCALe]:[LOGarithmic]:PDIVisi
on
:DISPlay:ACPower:VIEW[1]:WINDow[1]:TRACe:Y[:SCALe]:PDIVi
sion
:DISPlay:CHPower:VIEW[1]:WINDow[1]:TRACe:Y[:SCALe]:PDIVi
sion
:DISPlay:OBWidth:VIEW[1]:WINDow[1]:TRACe:Y[:SCALe]:PDIVi
sion
:DISPlay:BPOWer|:TXPower:VIEW[1]:WINDow[1]:TRACe:Y[:SCAL
e]:PDIVision