Anritsu MS2840A - [:SENSe]:RADio:STANdard:LOAD? <function>

2.8 Measure Function
2-347
2
SCPI Device Message Details
[:SENSe]:RADio:STANdard:LOAD? <function>
Load Standard Parameter Query
Function
This command queries the Measure function parameter. The parameter
selected for the Standard setting differs.
Query
[:SENSe]:RADio:STANdard:LOAD? <function>
Response
<pattern>
Parameter
Refer to
[:SENSe]:RADio:STANdard:LOAD <function>[,<pattern>]
Details
If the Standard parameter is not selected or is set to Off, *** is returned.
Example of Use
To query ACP measurement parameter.
RAD:STAN:LOAD? ADJ
> UPLINK