Anritsu MS2840A - [:SENSe]:BPOWer|:TXPower[:STATe] ON|OFF|1|0; :CALCulate:BPOWer|:TXPower[:STATe] ON|OFF|1|0

Chapter 2 SCPI Device Message Details
2-446
[:SENSe]:BPOWer|:TXPower[:STATe] ON|OFF|1|0
Measure Burst Average Power
Function
This command executes Burst Average Power measurement.
Command
[:SENSe]:BPOWer|:TXPower[:STATe] <switch>
Parameter
<switch>
Burst Average Power measurement On/Off
ON|1
Sets Burst Average Power measurement On.
OFF|0
Sets Burst Average Power measurement Off.
Example of Use
To set Burst Average Power measurement On.
BPOW ON
Related command
This command has the same function as the following command.
:CALCulate:BPOWer|:TXPower[:STATe]
:CALCulate:BPOWer|:TXPower[:STATe] ON|OFF|1|0
Measure Burst Average Power
Function
This command executes Burst Average Power measurement.
Refer to
[:SENSe]:BPOWer|:TXPower[:STATe].
Related command
This command has the same function as the following command.
[:SENSe]:BPOWer|:TXPower[:STATe]