Anritsu MS2840A - SEM:OFFS:LIST:SWE:TIME:AUTO;SEM:OFFS:LIST:SWE:TIME:AUTO?

Chapter
４
Native Device Message Details
4-249
4
Native Device Message Details
SEM:OFFS:LIST:SWE:TIME:AUTO/SEM:OFFS:LIST:SWE:TIME:AUTO?
Spectrum Emission Mask Offset Sweep Time Auto/Manual
Function
This command sets the sweep time of the offset for Spectrum Emission
Mask measurement automatically.
Command
SEM:OFFS:LIST:SWE:TIME:AUTO
switch_1_com[,switch_2_com[,switch_3_com[,switch_4_com[,
switch_5_com[,switch_6_com[,switch_7_com[,switch_8_com[,
switch_9_com[,switch_10_com[,switch_11_com[,switch_12_co
m]]]]]]]]]]]
Query
SEM:OFFS:LIST:SWE:TIME:AUTO?
Response
switch_1_res,switch_2_res,switch_3_res,switch_4_res,swit
ch_5_res,switch_6_res,switch_7_res,switch_8_res,switch_9
_res,switch_10_res,switch_11_res,switch_12_res
Parameter
switch_n_com
Automatic setting of the sweep time of Offset-n
ON|1
Enables the automatic setting function.
OFF|0
Disables the automatic setting function.
switch_n_res
Automatic setting of the sweep time of Offset-n
1
Enables the automatic setting function.
0
Disables the automatic setting function.
Details
The setting range of this function is limited depending on the settings of
other parameters. Refer to
MS2690A/MS2691A/MS2692A Signal
Analyzer Operation Manual (Spectrum Analyzer Function Operation)
or
MS2830A/MS2840A Signal Analyzer Operation Manual (Spectrum
Analyzer Function Operation)
for details.
Example of Use
To set the sweep time of the offset automatically.
SEM:OFFS:LIST:SWE:TIME:AUTO
OFF,OFF,OFF,OFF,OFF,OFF,OFF,OFF,OFF,OFF,OFF,OFF
SEM:OFFS:LIST:SWE:TIME:AUTO?
> 0,0,0,0,0,0,0,0,0,0,0,0