Anritsu MS2840A - [:SENSe]:SEMask:OFFSet[1]:LIST:BANDwidth[1]:VIDeo <bandwidth_1>|OFF [,<bandwidth_2>|OFF [,<bandwidth_3>|OFF [,<bandwidth_4>|OFF [,<bandwidth_5>|OFF [,<bandwidth_6>|OFF [,<bandwidth_7>|OFF [,<bandwidth_8>|OFF [,<bandwidth_9>|OFF [,<bandwidth_10>|OFF [...

Chapter 2 SCPI Device Message Details
2-608
[:SENSe]:SEMask:OFFSet[1]:LIST:BANDwidth[1]:VIDeo <bandwidth_1>|OFF
[,<bandwidth_2>|OFF [,<bandwidth_3>|OFF [,<bandwidth_4>|OFF
[,<bandwidth_5>|OFF [,<bandwidth_6>|OFF [,<bandwidth_7>|OFF
[,<bandwidth_8>|OFF [,<bandwidth_9>|OFF [,<bandwidth_10>|OFF
[,<bandwidth_11>|OFF [,<bandwidth_12>|OFF]]]]]]]]]]]
Spectrum Emission Mask Offset Video Bandwidth
Function
This command sets the video bandwidth (VBW) of the offset for Spectrum
Emission Mask measurement.
Command
[:SENSe]:SEMask:OFFSet[1]:LIST:BANDwidth[1]:VIDeo
<bandwidth_n>
Parameter
<bandwidth_n>
Video bandwidth of Offset-n (VBW)
Range/Resolution 1 Hz to 10 MHz (1-3 sequence), 5 kHz
Suffix code HZ,KHZ,KZ,MHZ,MZ,GHZ,GZ
Hz is used when omitted.
OFF
Sets VBW to Off.
Details
The setting range of this function is limited depending on the settings of
RBW. Refer to the
MS2690A/MS2691A/MS2692A Signal Analyzer
Operation Manual (Spectrum Analyzer Function Operation)
or
MS2830A/MS2840A Signal Analyzer Operation Manual (Spectrum
Analyzer Function Operation)
for details.
Example of Use
To set the video bandwidth of the offset.
SEM:OFFS:LIST:BAND:VID
3KHZ,3KHZ,3KHZ,10KHZ,10KHZ,10KHZ,3KHZ,3KHZ,3KHZ,10KHZ,10
KHZ,10KHZ