2.7 Sweep/Trigger/Gate
2-297
2
SCPI Device Message Details
Details
This setting is enabled when the gate signal source is wideband IF
detection (Wide IF Video).
Example of Use
To query the start level of the gate sweep.
SWE:EGAT:WIF:LEV:ABS?
> -10
[:SENSe]:SWEep:EGATe:SLOPe POSitive|NEGative
Gate Slope
Function
This command sets the detection mode for the gate signal.
Command
[:SENSe]:SWEep:EGATe:SLOPe <mode>
Parameter
<mode>
Detection mode for gate signal
POSitive
Detects at the rising edge.
NEGative D
etects at the falling edge.
Details
This setting can be applied when the gate signal source is wideband IF
detection (Wide IF Video), external input (External), SG marker, or
Baseband Interface (BBIF).
Example of Use
To detect at the rising edge.
SWE:EGAT:SLOP POS
To Next Page
Loading...
