Anritsu MS2840A - :CALCulate:LLINe[1]|2|3|4|5|6:ENVelope:SHAPe SQUare|SLOPe

2.6 Trace
2-233
2
SCPI Device Message Details
:CALCulate:LLINe[1]|2|3|4|5|6:ENVelope:SHAPe SQUare|SLOPe
Envelope Shape
Function
This command sets the shape of Limit Lines to be automatically created.
Command
:CALCulate:LLINe[1]|2|3|4|5|6:ENVelope:SHAPe <mode>
Parameter
<mode>
Shape of Limit Lines
SQUare
Connects Limit Points by vertical and horizontal
lines.
SLOPe
Connects Limit Points by straight lines.
(Default)
Details
This command is unavailable when the Mirror Limit is set to On.
Example of Use
To connect Limit Points by straight lines.
CALC:LLIN:ENV:SHAP SLOP