Anritsu MS2840A - [:SENSe]:SEMask:OFFSet[1]:LIST:ATTenuation <rel_ampl_1>|AUTO [,<rel_ampl_2>|AUTO [,<rel_ampl_3>|AUTO [,<rel_ampl_4>|AUTO [,<rel_ampl_5>|AUTO [,<rel_ampl_6>|AUTO [,<rel_ampl_7>|AUTO [,<rel_ampl_8>|AUTO [,<rel_ampl_9>|AUTO [,<rel_ampl_10>|AUTO [,<rel_a...

Chapter 2 SCPI Device Message Details
2-596
[:SENSe]:SEMask:OFFSet[1]:LIST:ATTenuation <rel_ampl_1>|AUTO
[,<rel_ampl_2>|AUTO [,<rel_ampl_3>|AUTO [,<rel_ampl_4>|AUTO
[,<rel_ampl_5>|AUTO [,<rel_ampl_6>|AUTO [,<rel_ampl_7>|AUTO
[,<rel_ampl_8>|AUTO [,<rel_ampl_9>|AUTO [,<rel_ampl_10>|AUTO
[,<rel_ampl_11>|AUTO [,<rel_ampl_12>|AUTO]]]]]]]]]]]
Spectrum Emission Mask Offset Attenuator
Function
This command sets the attenuation when measuring the offset for
Spectrum Emission Mask measurement.
Command
[:SENSe]:SEMask:OFFSet[1]:LIST:ATTenuation
<rel_ampl_n>|AUTO
Parameter
<rel_ampl_n>
Attenuation when measuring Offset-n
measurement
Range 0 to 60 dB
Resolution
[MS269xA]
2 dB
[MS2830A]
,
[MS2840A]
2 dB or 10 dB
Refer to “Table 2.4.2-3 Resolution of Input Attenuator” in the
MS2830A/MS2840A Signal Analyzer Operation Manual
(Spectrum Analyzer Function Operation)
.
Suffix code DB, dB is used when omitted.
AUTO
Sets the attenuation automatically.
Details
The setting range of this function is limited depending on the settings of
other parameters. Refer to the
MS2690A/MS2691A/MS2692A Signal
Analyzer Operation Manual (Spectrum Analyzer Function Operation)
or
MS2830A/MS2840A Signal Analyzer Operation Manual (Spectrum
Analyzer Function Operation)
for details.
Example of Use
To set the attenuation of the offset.
SEM:OFFS:LIST:ATT
10DB,10DB,10DB,10DB,10DB,10DB,10DB,10DB,10DB,10DB,10DB,1
0DB