Anritsu MS2840A - [:SENSe]:SEMask:OFFSet[1]:LIST:SWEep[1]:TIME:AUTO:MODE <mode_1>[,<mode_2>[,<mode_3>[,<mode_4>[,<mode_5>[,<mode_6>[,<mode_7>[,<mode_8>[,<mode_9>[,<mode_10>[,<mode_11>[,<mode_12>]]]]]]]]]]]

Chapter 2 SCPI Device Message Details
2-628
[:SENSe]:SEMask:OFFSet[1]:LIST:SWEep[1]:TIME:AUTO:MODE
<mode_1>[,<mode_2>[,<mode_3>[,<mode_4>[,<mode_5>[,<mode_6>[,<mo
de_7>[,<mode_8>[,<mode_9>[,<mode_10>[,<mode_11>[,<mode_12>]]]]]]]]]]]
Spectrum Emission Mask Offset Auto Sweep Time Select
Function
This command queries the sweep mode (Normal/Fast) when the
automatic sweep time setting function is enabled for the offset during
Spectrum Emission Mask measurement.
Command
[:SENSe]:SEMask:OFFSet[1]:LIST:SWEep[1]:TIME:AUTO:MODE
<mode_n>
Parameter
<mode_n>
Normal/Fast of sweep time of Offset-n
NORMal
Normal sweep mode
FAST
High-speed sweep mode
Example of Use
To set the sweep mode when the automatic sweep time setting function is
enabled for the offset.
SEM:OFFS:LIST:SWE:TIME:AUTO:MODE
NORM,NORM,NORM,NORM,NORM,NORM,NORM,NORM,NORM,NORM,NORM,N
ORM