Chapter
４
Native Device Message Details
4-324
SWE:EGAT:VIEW:BAND/SWE:EGAT:VIEW:BAND?
Gate View Resolution Bandwidth
Function
This command sets the resolution bandwidth (RBW) for Gate View.
This parameter and the one for setting the RBW for time axis
measurement reference the same value.
Command
SWE:EGAT:VIEW:BAND freq
Query
SWE:EGAT:VIEW:BAND?
Response
freq
Parameter
freq
Resolution bandwidth (RBW)
[MS269xA]
Range/Resolution 30 Hz to 31.25 MHz
However, the settable value is 30 Hz to 3 MHz
(1-3 sequence), 50 kHz, 5 MHz, 10 MHz, 20 MHz
or 31.25 MHz.
[MS2830A], [MS2840A]
Range/Resolution 30 Hz to 31.25 MHz
However, the settable value is 30 Hz to 3 MHz
(1-3 sequence), 500 Hz, 50 kHz, 2 MHz, 5 MHz,
10 MHz, 20 MHz or 31.25 MHz.
[Common]
Suffix code HZ, KHZ, KZ, MHZ, MZ, GHZ, GZ
Hz is used when omitted.
Details
The automatic resolution bandwidth setting function is disabled when
the resolution bandwidth (RBW) is changed.
This command is not available when Gate View is set to Off.
Example of Use
To set the RBW for Gate View to 3 kHz.
SWE:EGAT:VIEW:BAND 3KHZ
SWE:EGAT:VIEW:BAND?
> 3000
To Next Page
Loading...
