Chapter 2 SCPI Device Message Details
2-488
[:SENSe]:CHPower:FILTer[:RRC][:STATe] ON|OFF|1|0
Channel Power Filter Type
Function
This command sets filter type for Channel Power measurement.
Command
[:SENSe]:CHPower:FILTer[:RRC][:STATe] <filter>
Parameter
<filter>
Filter type
0|OFF
Rectangle filter
1|ON
Root Nyquist filter (Default)
Example of Use
To set filter type to Root Nyquist.
CHP:FILT 1
Related command
This command has the same function as the following commands.
[:SENSe]:CHPower:FILTer:TYPE
:CALCulate:CHPower:FILTer[:RRC][:STATe]
:CALCulate:CHPower:FILTer[:RRC][:STATe] ON|OFF|1|0
Channel Power Filter Type
Function
This command sets filter type for Channel Power measurement.
Refer to
[:SENSe]:CHPower:FILTer[:RRC][:STATe].
Related command
This command has the same function as the following commands.
[:SENSe]:CHPower:FILTer:TYPE
[:SENSe]:CHPower:FILTer[:RRC][:STATe]
To Next Page
Loading...
