Anritsu MS2840A - [:SENSe]:SPURious[:RANGe][:LIST]:SWEep:TIME:AUTO ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0, ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0, ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0, ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,...

2.14 Spurious Emission Measurement Function
2-755
2
SCPI Device Message Details
[:SENSe]:SPURious[:RANGe][:LIST]:SWEep:TIME:AUTO
ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,
ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,
ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,
ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0
Spurious Emission Sweep Time Auto/Manual
Function
This command sets the sweep time of each segment to Auto/Manual.
Command
[:SENSe]:SPURious[:RANGe][:LIST]:SWEep:TIME:AUTO
<switch_n>
Parameter
<switch_n>
Sweep time of Segment n Auto/Manual
ON|1
Sweep Time is set to Auto.
OFF|0
Sweep Time is set to Manual.
Default Auto value
Example of Use
To set the sweep time of each segment to Auto/Manual.
SPUR:SWE:TIME:AUTO
ON,ON,OFF,ON,ON,OFF,ON,ON,OFF,ON,ON,OFF,ON,ON,OFF,ON,ON,
OFF,ON,ON