Anritsu MS2840A - SPUR:FST;SPUR:FST?

Chapter
４
Native Device Message Details
4-287
4
Native Device Message Details
Example of Use
To set the stop frequency of each segment.
SPUR:FREQ:STOP
150kHz,40MHz,1.1GHz,12.5GHz,12.5GHz,12.5GHz,12.5GHz,12.5
GHz,12.5GHz,12.5GHz,12.5GHz,12.5GHz,12.5GHz,12.5GHz,12.5
GHz,12.5GHz,12.5GHz,12.5GHz,12.5GHz,12.5GHz
SPUR:FREQ:STOP?
>
150000,40000000,1100000000,12500000000,12500000000,12500
000000,12500000000,12500000000,12500000000,12500000000,1
2500000000,12500000000,12500000000,12500000000,125000000
00,12500000000,12500000000,12500000000,12500000000,12500
000000
SPUR:FST/SPUR:FST?
Fail Stop
Function
This command sets whether to stop the measurement when a “Fail”
segment has been found.
Command
SPUR:FST switch_com
Query
SPUR:FST?
Response
switch_res
Parameter
switch_com
Fail Stop On/Off
ON|1
Fail Stop is set to On.
OFF|0
Fail Stop is set to Off.
switch_res
Fail Stop On/Off
1
Fail Stop is set to On.
0
Fail Stop is set to Off.