Anritsu MS2840A - [:SENSe]:ACPower:OFFSet[1]:LIST[:FREQuency] <freq>,<freq>,<freq>; :CALCulate:ACPower:OFFSet[1]:LIST[:FREQuency] <freq>,<freq>,<freq>

2.9 ACP
2-377
2
SCPI Device Message Details
[:SENSe]:ACPower:OFFSet[1]:LIST[:FREQuency] <freq>,<freq>,<freq>
Adjacent Channel Power Offset Frequency
Function
This command sets the offset frequency of Offset Channel for Adjacent
Channel Power measurement.
Command
[:SENSe]:ACPower:OFFSet[1]:LIST[:FREQuency]
<freq_1>,<freq_2>,<freq_3>
Parameter
<freq_n>
Offset frequency of offset channel “n”.
Range –1000000000 to 1000000000 Hz
Resolution 1 Hz
Suffix code HZ,KHZ,KZ,MHZ,MZ,GHZ,GZ
Hz is used when omitted.
Default
freq-1
5 MHz
freq-2
10 MHz
freq-3
15 MHz
Example of Use
To set the offset frequency of the offset channel.
ACP:OFFS:LIST 30KHZ,50KHZ,50KHZ
Related command
This command has the same function as the following command.
:CALCulate:ACPower:OFFSet[1]:LIST[:FREQuency]
:CALCulate:ACPower:OFFSet[1]:LIST[:FREQuency] <freq>,<freq>,<freq>
Adjacent Channel Power Offset Frequency
Function
This command sets the offset frequency of Offset Channel for Adjacent
Channel Power measurement.
Refer to
[:SENSe]:ACPower:OFFSet[1]:LIST[:FREQuency].
Related command
This command has the same function as the following command.
[:SENSe]:ACPower:OFFSet[1]:LIST[:FREQuency]