Anritsu MS2840A - [:SENSe]:BANDwidth|:BWIDth:VIDeo:AUTO ON|OFF|1|0

Chapter 2 SCPI Device Message Details
2-96
[:SENSe]:BANDwidth|:BWIDth:VIDeo:AUTO ON|OFF|1|0
Video Bandwidth Auto/Manual
Function
This command enables/disables the automatic video bandwidth (VBW)
setting function. When Couple Time/Freq. Domain is set to Off, each
parameter is specified in accordance with the already-specified frequency
axis or time axis measurement.
Command
[:SENSe]:BANDwidth|:BWIDth:VIDeo:AUTO <switch>
Parameter
<switch>
Automatic video bandwidth setting function
On/Off
0|OFF
Disables the automatic video bandwidth setting
function.
1|ON
Enables the automatic video bandwidth setting
function (Default).
Details
This command is not available during the Spectrum Emission Mask
measurement or the Spurious Emission measurement.
Example of Use
To enable the automatic video bandwidth setting function.
BAND:VID:AUTO ON
Related command
This command has the same function as the following commands.
[:SENSe]:ACPower:BANDwidth:VIDeo
[:SENSe]:CHPower:BANDwidth:VIDeo
[:SENSe]:OBWidth:BANDwidth:VIDeo