Chapter
４
Native Device Message Details
4-38
CALC:MARK:COUP:ZONE/ CALC:MARK:COUP:ZONE?
Couple Zone
Function
This command sets the Zone Width shared setting to On/Off.
Command
CALC:MARK:COUP:ZONE switch_com
Query
CALC:MARK:COUP:ZONE?
Response
switch_res
Parameter
switch_com
Zone Width shared setting On/Off
ON|1
Sets the shared setting to On.
OFF|0
Sets the shared setting to Off.
switch_res
Zone Width shared setting On/Off
1
Shared setting is set to On.
0
Shared setting is set to Off.
Details
This command allows the markers to share the Zone Width setting when
set to On.
This command is not available in the following cases:
•
In Time Domain mode.
•
During the Spurious Emission measurement and when the Displayed
Segment Mode is set to Auto.
•
During the Spectrum Emission Mask measurement.
Example of Use
To set the Zone Width shared setting to On.
CALC:MARK:COUP:ZONE ON
CALC:MARK:COUP:ZONE?
> 1
To Next Page
Loading...
