Chapter 2 SCPI Device Message Details
2-54
[:SENSe]:FREQuency:SYNThesis[:STATe]?
Switching Speed Query
Function
This command queries the switching speed of frequency.
Query
[:SENSe]:FREQuency:SYNThesis[:STATe]?
Response
<mode>
Parameter
<mode>
Frequency switching speed
BPH
The operation is done so as to improve the phase
noise characteristic rather than the frequency
switching speed.
FAST
The operation is done so as to increase the
frequency switching speed.
Details
This command is available for MS2830A and MS2840A.
Note that because the FAST setting gives priority to the switching speed
of the local frequency, the phase noise characteristic worsens.
Example of Use
To query frequency switching speed
FREQ:SYNT?
> FAST
To Next Page
Loading...
