Anritsu MS2840A - [:SENSe]:SPURious[:RANGe][:LIST]:BANDwidth[:RESolution] <bandwidth_1>,<bandwidth_2>,<bandwidth_3>,<bandwidth_4>,<bandwidth_5>,<bandwidth_6>,<bandwidth_7>,<bandwidth_8>,<bandwidth_9>,<bandwidth_10>,<bandwidth_11>,<bandwidth_12>,<bandwidth_13>,<bandwid...

Chapter 2 SCPI Device Message Detail
2-748
[:SENSe]:SPURious[:RANGe][:LIST]:BANDwidth[:RESolution]
<bandwidth_1>,<bandwidth_2>,<bandwidth_3>,<bandwidth_4>,<bandwidth_
5>,<bandwidth_6>,<bandwidth_7>,<bandwidth_8>,<bandwidth_9>,<bandwidt
h_10>,<bandwidth_11>,<bandwidth_12>,<bandwidth_13>,<bandwidth_14>,<
bandwidth_15>,<bandwidth_16>,<bandwidth_17>,<bandwidth_18>,<bandwid
th_19>,<bandwidth_20>
Spurious Emission Resolution Bandwidth
Function
This command sets the resolution bandwidth (RBW) of each segment.
Command
[:SENSe]:SPURious[:RANGe][:LIST]:BANDwidth[:RESolution]
<bandwidth_n>
Parameter
<bandwidth_n>
Resolution bandwidth (RBW) of Segment n
[MS269xA]
Range/Resolution Set to any of 30 Hz to 3 MHz (1-3 sequence), 50
kHz, 5 MHz, 10 MHz, and 20 MHz.
[MS2830A]
，
[MS2840A]
Range/Resolution Set to any of 30 Hz to 3 MHz (1-3 sequence), 500
Hz, 50 kHz, 2 MHz, 5 MHz, 10 MHz, and 20
MHz.
[Common]
Suffix Code HZ,KHZ,KZ,MHZ,MZ,GHZ,GZ
Hz is used when omitted.
Default
[MS269xA]
Segment 1 1 kHz
Segment 2 10 kHz
Segment 3 100 kHz
Segment 4 to 8 1 MHz
Segment 9 to 15 1 MHz (Auto for MS2690A)
Segment 16 to 20 Auto value
[MS2830A]
，
[MS2840A]
Segment 1 1 kHz
Segment 2 10 kHz
Segment 3 100 kHz
Segment 4 to 6 1 MHz
[MS2830A]
Segment 7 to 8 1 MHz (Auto for Option 040)