Anritsu MS2840A - NOISECANCEL;NOISECANCEL?

Chapter
４
Native Device Message Details
4-183
4
Native Device Message Details
Example of Use
To set the zone marker width to 1 MHz.
MZWF 1MHZ
MZWF?
> 1000000.00
NOISECANCEL/NOISECANCEL?
Noise Cancel
Function
This command sets whether to enable the noise canceling function.
Command
NOISECANCEL on_off
Query
NOISECANCEL?
Response
on_off
Parameter
on_off
Noise canceling function On/Off
ON
Enables the noise canceling function.
OFF
Disables the noise canceling function.
Details
This command is not available in the following cases:
•
ACP and Burst Average Power are Off.
•
Standard is Off.
•
Standard Parameter which can execute the noise canceling function is
not set in Load Standard Parameter.
•
Any of Span, RBW, Detection, Sweep Time, VBW (when Detection is
not set to RMS), and VBW Mode (when VBW is not set to Off and when
Detection is not set to RMS) has been changed from Standard
Parameter.
•
Scale Mode is Linear.
Example of Use
To disable the noise canceling function.
NOISECANCEL OFF
NOISECANCEL?
> OFF