Anritsu MS2840A - :MEASure:BATCh:OBWidth[n]? <filename>[,<device>]

2.17 Configuring Batch Measurement Settings
2-865
2
SCPI Device Message Details
:MEASure:BATCh:OBWidth[n]? <filename>[,<device>]
Occupied Bandwidth Batch Measure
Function
This command executes OBW measurement and outputs the
measurement result after the parameters described in the specified
parameter list file have been set.
Query
:MEASure:BATCh:OBWidth[n]? <filename>[,<device>]
Response
The same value as for
:MEASure:OBWidth[n]?
is returned.
Refer to
:MEASure:OBWidth[n]?
for details.
Parameter
<filename>
Parameter list file
Specify with any character string enclosed by
double quotes (" ") or single quotes (' ').
<device>
Drive name
A,B,D,E,F,...
D drive is used when omitted.
Details
OBW measurement is executed and the result is output after the
parameters described in the specified parameter list have been set.
The return values of this function vary depending on the result mode.
(cf.
:SYSTem:RESult:MODE
)
Place the parameter list files in the following folder on the specified
drive.
<device>:\Anritsu Corporation\Signal Analyzer\User Data\Batch
If the parameter list file has been changed, the changes must be applied
with the
:MMEMory:RELoad:BATCh
command.
(cf.
:MMEMory:RELoad:BATCh
)
Example of Use
To acquire the measurement result of OBW measurement using the
MyParam.xls parameter list file.
(
A mode, n = 1)
READ:BATC:OBW? "MyParam"
> 30000,1000000000,900050000,1000050000