Chapter 2 SCPI Device Message Details
2-176
Example of Use
To query the On/Off state of the threshold when searching for the peak
point.
CALC:MARK:PEAK:THR:STAT?
> 1
:CALCulate:MARKer:PEAK:THReshold:MODE ABOVe|BELow
Peak Search Mode
Function
This command specifies the detection mode for the threshold value (Peak
Search Threshold Level) in peak point detection.
Command
:CALCulate:MARKer:PEAK:THReshold:MODE <mode>
Parameter
<mode>
Threshold value detection mode
ABOVe
Detects only in the range above the threshold
value (Default).
BELow
Detects only in the range below the threshold
value.
Details
This command is not available during Spurious Emission measurement
and when Displayed Segment Mode is Auto.
Not available during Spectrum Emission Mask measurement.
Example of Use
To search for the peak point from the data greater than the threshold
value.
CALC:MARK:PEAK:THR:MODE ABOV
To Next Page
Loading...
