2.10 Burst Average Power
2-455
2
SCPI Device Message Details
:CONFigure:BPOWer|:TXPower
Burst Average Power Configure
Function
This command sets Burst Average Power measurement to On.
Command
:CONFigure:BPOWer|:TXPower
Details
No measurement is executed.
Example of Use
To set Burst Average Power measurement to On.
CONF:BPOW
:INITiate:BPOWer|:TXPower
Burst Average Power Initiate
Function
This command starts Burst Average Power measurement.
Command
:INITiate:BPOWer|:TXPower
Details
Burst Average Power measurement is set to On and the measurement
starts, when this function is executed.
To read out the measurement results after executing this command,
perform the synchronization control using the “*WAI” command.
Example of Use
To start Burst Average Power measurement.
INIT:BPOW
To Next Page
Loading...
