Anritsu MS2840A - :CALCulate:MATH <active_trace>,<math_type>[,<operand1_trace>,<operand2_trace>]

Chapter 2 SCPI Device Message Details
2-244
:CALCulate:MATH
<active_trace>,<math_type>[,<operand1_trace>,<operand2_trace>]
Math
Function
This command performs calculations between traces.
Command
:CALCulate:MATH
<active_trace>,<math_type>[,<operand1_trace>,<operand2_t
race>]
Parameter
<active_trace>
Type of trace to be activated
TRACe1
Trace A (Default)
TRACe2
Trace B
TRACe3
Trace C
TRACe4
Trace D
TRACe5
Trace E
TRACe6
Trace F
<math_type>
Calculation type
OFF
Disables the Math function (Default)
PDIFference
Operand1 – Operand2 (Power
subtraction)
PSUM
Operand1 + Operand2 (Power
addition)
LDIFference
Operand1 – Operand2 (Log
subtraction)
LSUM
Operand1 + Operand2 (Log
addition)
<operand1_trace>
Type of trace for Operand1
TRACe1
Trace A
TRACe2
Trace B
TRACe3
Trace C
TRACe4
Trace D
TRACe5
Trace E (Default)
TRACe6
Trace F
When omitted: Trace type for Operand1 is not changed.
<operand2_trace>
Type of trace for Operand2
TRACe1
Trace A
TRACe2
Trace B
TRACe3
Trace C
TRACe4
Trace D
TRACe5
Trace E
TRACe6
Trace F (Default)
When omitted: Trace type for Operand2 is not changed.
Details
This command is available only for MS2830A.
This cannot select the calculation type under the following conditions: