Anritsu MS2840A - :CALCulate:MARKer[1]|2|3|4|5|6|7|8|9|10:X:DELTa <freq>|<time>

2.4 Marker
2-115
2
SCPI Device Message Details
:CALCulate:MARKer[1]|2|3|4|5|6|7|8|9|10:X:DELTa <freq>|<time>
Zone Marker Relative Frequency (Time)
Function
This command moves the center of the zone marker to the frequency
(time), specified by relative value.
Command
:CALCulate:MARKer[n]:X:DELTa <freq>|<time>
Parameter
<n> Marker Number
1
Specifies marker 1
2
Specifies marker 2
3
Specifies marker 3
4
Specifies marker 4
5
Specifies marker 5
6
Specifies marker 6
7
Specifies marker 7
8
Specifies marker 8
9
Specifies marker 9
10
Specifies marker 10
When omitted: Specifies marker 1
<freq>
Relative center frequency of zone maker
Range Absolute frequency range – Reference marker
center frequency
Resolution 0.01 Hz
Suffix code HZ, KHZ, KZ, MHZ, MZ, GHZ, GZ
Hz is used when omitted.
Default 0 Hz
<time>
Relative center time of zone marker
Range Absolute time range – Reference marker center
time
Resolution 1 ns
Suffix code NS, US, MS, S
S is used when the suffix code is omitted.
Default 0 s
Details
This command is not available during Spurious Emission measurement
and when Displayed Segment Mode is Auto.
Not available during Spectrum Emission Mask measurement.
Not available when Marker Mode is set other than Delta.
Example of Use