Anritsu MS2840A - [:SENSe]:CHPower:FREQuency:CENTer <freq>; :CALCulate:CHPower:FREQuency:CENTer <freq>

Chapter 2 SCPI Device Message Details
2-482
[:SENSe]:CHPower:FREQuency:CENTer <freq>
Channel Power Channel Center Frequency
Function
This command sets the center frequency for Channel Power
measurement.
Command
[:SENSe]:CHPower:FREQuency:CENTer <freq>
Parameter
<freq>
Channel center frequency
Range (Start Frequency) to (Stop Frequency)
Resolution 1 Hz
Suffix code HZ,KHZ,KZ,MHZ,MZ,GHZ,GZ
Hz is used when omitted.
Default Center Frequency
Example of Use
To set the channel power center frequency to 6.01 GHz.
CHP:FREQ:CENT 6.01GHZ
Related command
This command has the same function as the following command.
:CALCulate:CHPower:FREQuency:CENTer
:CALCulate:CHPower:FREQuency:CENTer <freq>
Channel Power Channel Center Frequency
Function
This command sets the center frequency for Channel Power
measurement.
Refer to
[:SENSe]:CHPower:FREQuency:CENTer.
Related command
This command has the same function as the following command.
[:SENSe]:CHPower:FREQuency:CENTer