Anritsu MS2840A - SPUR:FREQ:STOP;SPUR:FREQ:STOP?

Chapter
４
Native Device Message Details
4-286
>
9000,100000,40000000,11000000000,1000000000,1000000000,1
000000000,1000000000,1000000000,1000000000,1000000000,10
00000000,1000000000,1000000000,1000000000,1000000000,100
0000000,1000000000,1000000000,1000000000
SPUR:FREQ:STOP/SPUR:FREQ:STOP?
Spurious Emission Stop Frequency
Function
This command sets the stop frequency of each segment.
Command
SPUR:FREQ:STOP
freq_1,freq_2,freq_3,freq_4,freq_5,freq_6,freq_7,freq_8,
freq_9,freq_10,freq_11,freq_12,freq_13,freq_14,freq_15,f
req_16,freq_17,freq_18,freq_19,freq_20
Query
SPUR:FREQ:STOP?
Response
freq_1,freq_2,freq_3,freq_4,freq_5,freq_6,freq_7,freq_8,
freq_9,freq_10,freq_11,freq_12,freq_13,freq_14,freq_15,f
req_16,freq_17,freq_18,freq_19,freq_20
Value is returned in Hz units, without a suffix code.
Parameter
freq_n
Stop frequency of Segment n
Range
[MS269xA]
–99.9997 MHz to 6.05 GHz (MS2690A)
–99.9997 MHz to 13.6 GHz (MS2691A)
–99.9997 MHz to 26.6 GHz (MS2692A)
[MS2830A]
–99.9997 MHz to 3.7 GHz (MS2830A-040)
–9.9997 MHz to 6.1 GHz (MS2830A-041)
–99.9997 MHz to 13.6 GHz (MS2830A-043)
–99.9997 MHz to 26.6 GHz (MS2830A-044)
–99.9997 MHz to 43.1 GHz (MS2830A-045)
[MS2840A]
–99.9997 MHz to 3.7 GHz (MS2840A-040)
–9.9997 MHz to 6.1 GHz (MS2840A-041)
–99.9997 MHz to 27 GHz (MS2840A-044)
–99.9997 MHz to 45 GHz (MS2840A-046)
Resolution 1 Hz
Suffix code HZ,KHZ,KZ,MHZ,MZ,GHZ,GZ
Hz is used when omitted.