Anritsu MS2840A - :CALCulate:LLINe[1]|2|3|4|5|6:TYPE?; :CALCulate:LLINe[1]|2|3|4|5|6:DISPlay OFF|ON|0|1

Chapter 2 SCPI Device Message Details
2-198
:CALCulate:LLINe[1]|2|3|4|5|6:TYPE?
Limit Type Query
Function
This command queries the Limit Line type setting.
Query
:CALCulate:LLINe[1]|2|3|4|5|6:TYPE?
Response
<mode>
Parameter
<mode>
Type of Limit Line
UPP
Upper Limit
LOW
Lower Limit
Example of Use
To query the Limit Line type setting.
CALC:LLIN:TYPE?
> LOW
:CALCulate:LLINe[1]|2|3|4|5|6:DISPlay OFF|ON|0|1
Limit Display
Function
This command sets the Limit Display to On/Off.
Command
:CALCulate:LLINe[1]|2|3|4|5|6:DISPlay <switch>
Parameter
<switch>
Limit Display On/Off
OFF|0
Limit Line display Off (Default)
ON|1
Limit Line display On
Details
When Limit Display is set to On, Limit Line is displayed on the
measurement screens. When Limit Display is set to Off, Limit Line is not
displayed on the measurement screens.
Example of Use
To set Limit Display to Off.
CALC:LLIN:DISP OFF