Anritsu MS2840A - [:SENSe]:FREQuency:BAND:MODE?

Chapter 2 SCPI Device Message Details
2-50
[:SENSe]:FREQuency:BAND:MODE?
Frequency Band Mode Query
Function
This command queries the frequency band path. The frequency at which
the path is switched to the preselector band or a path that does not pass
through the preselector can be set with this function.
Query
[:SENSe]:FREQuency:BAND:MODE?
Response
<mode>
Parameter
<mode>
Frequency band mode
[MS269xA]
NORMal
Sets the frequency to be switched to the
preselector band to 6.0 GHz.
SPURious
Sets the frequency to be switched to the
preselector band to 3.0 GHz.
[MS2830A-041/043/044/045]
NORMal
Sets the frequency to be switched to the
preselector band to 4.0 GHz.
SPURious
Sets the frequency to be switched to the
preselector band to 3.5 GHz.
[MS2840A-041/044/046]
NORMal
Sets the frequency to be switched to the
preselector band to 4.0 GHz.
SPURious
Sets the frequency to be switched to the
preselector band to 3.5 GHz.
Example of Use
To query the frequency band path.
FREQ:BAND:MODE?
> NORM