Anritsu MS2840A - :CALCulate:MARKer:SLINe[:STATe]?; :CALCulate:MARKer:COUPle:ZONE[:STATe] OFF|ON|0|1

Chapter 2 SCPI Device Message Details
2-124
:CALCulate:MARKer:SLINe[:STATe]?
Spot Line Query
Function
This command queries the On/Off state of the marker line display setting
in spot marker.
Query
:CALCulate:MARKer:SLINe[:STATe]?
Response
<switch>
Parameter
<switch>
Marker line display On/Off
1
Displays the marker line.
0
Hides the marker line.
Example of Use
To query the On/Off state of the marker line display setting.
CALC:MARK:SLIN?
> 1
:CALCulate:MARKer:COUPle:ZONE[:STATe] OFF|ON|0|1
Couple Zone
Function
This command sets Zone Width shared setting On/Off.
Command
:CALCulate:MARKer:COUPle:ZONE[:STATe] <switch>
Parameter
<switch>
Zone Width shared setting On/Off
ON|1
Sets the shared setting to On.
OFF|0
Sets the shared setting to Off.
Details
Shares the Zone Width setting of each marker when set to On.
Not available during Time Domain.
This command is not available during the time domain measurement.
Not available during Spectrum Emission Mask measurement.
Example of Use
To set the Zone Width shared setting to On.
CALC:MARK:COUP:ZONE ON