Anritsu MS2840A - [:SENSe]:SEMask:BANDwidth[1][:RESolution]:AUTO?

2.13 Spectrum Emission Mask
2-601
2
SCPI Device Message Details
[:SENSe]:SEMask:BANDwidth[1][:RESolution]:AUTO?
Spectrum Emission Mask Resolution Bandwidth Auto/Manual Query
Function
This command queries the On/Off state of the automatic resolution
bandwidth (RBW) setting function for the reference channel for
Spectrum Emission Mask measurement.
Query
[:SENSe]:SEMask:BANDwidth[1][:RESolution]:AUTO?
Response
<switch>
Parameter
<switch>
Automatic resolution bandwidth (RBW) setting
function On/Off state
1
Automatic resolution bandwidth setting function
is enabled.
0
Automatic resolution bandwidth setting function
is disabled.
Details
The setting range of this function is limited depending on the settings of
other parameters. Refer to the
MS2690A/MS2691A/MS2692A Signal
Analyzer Operation Manual (Spectrum Analyzer Function Operation)
or
MS2830A/MS2840A Signal Analyzer Operation Manual (Spectrum
Analyzer Function Operation)
for details.
Example of Use
To query the On/Off state of the automatic resolution bandwidth (RBW)
setting function for the reference channel.
SEM:BAND:AUTO?
> 1