Anritsu MS2840A - :CALCulate:SGControl:POWer <numeric_value>

Chapter 2 SCPI Device Message Detail
2-852
:CALCulate:SGControl:POWer <numeric_value>
Internal Signal Generator Control SG Output Level
Function
This command sets the SG output level when Internal Signal Generator
Control measurement is executed.
Command
:CALCulate:SGControl:POWer
Parameter
<numeric_value>
SG output level
Range –40.00 to +20.00 dBm (Start Frequency > 25 MHz) (*)
–40.00 to +2.00 dBm (Start Frequency ≤ 25 MHz) (*)
–136.00 to +15.00 dBm (Start Frequency > 25 MHz) (**)
–136.00 to –3.00 dBm (Start Frequency ≤ 25 MHz) (**)
Resolution 0.01 dB
Default –40.00 dBm (*)
–136.00 dBm (**)
Suffix code DBM, dBm is used even when omitted.
(*) without Option 022/122
(**) with Option 022/122
Details
This command is available only for MS2830A.
This function is available when MS2830A-052/152/352 is installed.
Example of Use
To set the SG output level to –30.00 dBm.
CALC:SGC:POW –30.00DBM