Anritsu MS2840A - [:SENSe]:SEMask:OFFSet[1]:LIST:BANDwidth[1][:RESolution] <bandwidth_1>[,<bandwidth_2>[,<bandwidth_3>[,<bandwidth_4>[,<bandwidth_5>[,<bandwidth_6>[,<bandwidth_7>[,<bandwidth_8>[,<bandwidth_9>[,<bandwidth_10>[,<bandwidth_11>[,<bandwidth_12>]]]]]]]]]]]

Chapter 2 SCPI Device Message Details
2-602
[:SENSe]:SEMask:OFFSet[1]:LIST:BANDwidth[1][:RESolution]
<bandwidth_1>[,<bandwidth_2>[,<bandwidth_3>[,<bandwidth_4>[,<bandwidt
h_5>[,<bandwidth_6>[,<bandwidth_7>[,<bandwidth_8>[,<bandwidth_9>[,<ba
ndwidth_10>[,<bandwidth_11>[,<bandwidth_12>]]]]]]]]]]]
Spectrum Emission Mask Offset Resolution Bandwidth
Function
This command sets the resolution bandwidth (RBW) of the offset for
Spectrum Emission Mask measurement.
Command
[:SENSe]:SEMask:OFFSet[1]:LIST:BANDwidth[1][:RESolution]
<bandwidth_n>
Parameter
<bandwidth_n>
Resolution bandwidth (RBW) of Offset-n
[MS269xA]
Range/Resolution 30 Hz to 3 MHz (1-3 sequence),
50 kHz, 5 MHz, 10 MHz, 20 MHz
[MS2830A], [MS2840A]
Range/Resolution 30 Hz to 3 MHz (1-3 sequence),
500 Hz, 50 kHz, 2 MHz, 5 MHz, 10 MHz, 20
MHz
[Common]
Suffix code HZ,KHZ,KZ,MHZ,MZ,GHZ,GZ
Hz is used when omitted.
Details
For MS2830A, MS2840A, RBW 20 MHz or greater is only available for
MS2830A-005/105/007/009/109, MS2840A-005/105/009/109.
The setting range of this function is limited depending on the settings of
other parameters. Refer to the
MS2690A/MS2691A/MS2692A Signal
Analyzer Operation Manual (Spectrum Analyzer Function Operation)
or
MS2830A/MS2840A Signal Analyzer Operation Manual (Spectrum
Analyzer Function Operation)
for details.
Example of Use
To set the resolution bandwidth of the offset.
SEM:OFFS:LIST:BAND
30KHZ,30KHZ,30KHZ,1MHZ,1MHZ,1MHZ,30KHZ,30KHZ,30KHZ,1MHZ,
1MHZ,1MHZ