Anritsu MS2840A - :CALCulate:MARKer[1]|2|3|4|5|6|7|8|9|10:MAXimum

Chapter 2 SCPI Device Message Details
2-164
:CALCulate:MARKer[1]|2|3|4|5|6|7|8|9|10:MAXimum
Peak Search
Function
This command searches for the peak point of active trace and moves the
marker point.
Command
:CALCulate:MARKer[n]:MAXimum
Parameter
<n>
Marker number
1
Marker 1
2
Marker 2
3
Marker 3
4
Marker 4
5
Marker 5
6
Marker 6
7
Marker 7
8
Marker 8
9
Marker 9
10
Marker 10
When omitted: Marker 1
Details
This command is not available during Spurious Emission measurement
and when Displayed Segment Mode is Auto.
Not available during Spectrum Emission Mask measurement.
Example of Use
To move the marker 1 to the maximum level point.
CALC:MARK:MAX
Related command
This command has the same function as the following commands.
:CALCulate:ACPower:MARKer[1]|2|3|4|5|6|7|8|9|10:MAXimum
:CALCulate:CHPower:MARKer[1]|2|3|4|5|6|7|8|9|10:MAXimum
:CALCulate:OBWidth:MARKer[1]|2|3|4|5|6|7|8|9|10:MAXimum
:CALCulate:BPOWer|:TXPower:MARKer[1]|2|3|4|5|6|7|8|9|10:
MAXimum