Anritsu MS2840A - [:SENSe]:SPURious[:RANGe][:LIST]:SWEep:TIME:AUTO?

Chapter 2 SCPI Device Message Detail
2-756
[:SENSe]:SPURious[:RANGe][:LIST]:SWEep:TIME:AUTO?
Spurious Emission Sweep Time Auto/Manual Query
Function
This command queries the Auto/Manual state of the sweep time in each
segment.
Query
[:SENSe]:SPURious[:RANGe][:LIST]:SWEep:TIME:AUTO?
Response
<switch_n>
Parameter
<switch_n>
Sweep time of Segment n Auto/Manual
1
Sweep Time is set to Auto.
0
Sweep Time is set to Manual.
Example of Use
To query the Auto/Manual state of the sweep time in each segment.
SPUR:SWE:TIME:AUTO?
> 1,1,0,1,1,0,1,1,0,1,1,0,1,1,0,1,1,0,1,1