Chapter 3 Native Device Message List
3-1
3
Native Device Message List
This chapter describes remote control commands for executing the
spectrum analyzer function (hereinafter referred to as “this
application”) using a list organized by functions. Refer to Chapter 4
“Native Device Message Details” for detailed specifications for each
command. Refer to the
MS2690A/MS2691A/MS2692A and
MS2830A/MS2840A Signal Analyzer Operation Manual (Mainframe
Remote Control)
for detailed specifications on IEEE488.2 common
device messages and application common device messages.
Some functions of this instrument only correspond to SCPI commands.
You can perform a remote control of the function in Native mode by
replacing the corresponding SCPI commands with Native ones.
Refer to Section 1.6.2 “How to use SCPI commands in Native mode” in
MS2690A/MS2691A/MS2692A and MS2830A/MS2840A Signal Analyzer
Operation Manual (Main unit Remote Control)
for the replacement. Also,
refer to Chapter 2 “SCPI Device Messages” for detailed specifications on
SCPI commands.
3.1
IEEE488.2 Common Device Messages ....................... 3-3
3.2
Application Common Device Messages ....................... 3-5
3.3
Frequency/Span Settings ............................................. 3-7
3.4
Level Settings ............................................................... 3-8
3.5
RBW/VBW Settings ...................................................... 3-9
3.6
Marker Settings ........................................................... 3-10
3.7
Signal Search Settings ............................................... 3-13
3.8
Trace Settings ............................................................. 3-15
3.9
Sweep/Trigger/Gate Settings ...................................... 3-18
3.10
Measure Function Settings ......................................... 3-23
3.10.1
Common Measure function settings ............... 3-23
3.10.2
Adjacent channel power measurement
function settings .............................................. 3-24
3.10.3
Burst average power measurement function
settings ........................................................... 3-28
3.10.4
Channel power measurement function
settings ........................................................... 3-29
3.10.5
Occupied Bandwidth measurement function
settings ........................................................... 3-30
3.10.6
Spectrum Emission Mask Measurement function
settings ........................................................... 3-31
3.10.7
Spurious Emission Measurement function
settings ........................................................... 3-45
3.11
Batch Measure Function Settings ............................... 3-52
To Next Page
Loading...
