Anritsu MS2840A - :OUTPut[:STATe] ON|OFF|1|0

Chapter 2 SCPI Device Message Detail
2-854
:OUTPut[:STATe] ON|OFF|1|0
Internal Signal Generator Output
Function
This command turns RF output On/Off in the Internal Signal Generator
Control function.
Command
:OUTPut[:STATe] <switch>
Parameter
<switch>
RF output On/Off
ON|1 Turns on RF output.
OFF|0 Turns off RF output. (Default)
Details
This command is available only for MS2830A.
This function is available when MS2830A-052/152/352 is installed.
When RF output is turned On, Internal Signal Generator Control is On.
When Internal Signal Generator Control is turned Off, RF output is Off.
Example of Use
To set the RF signal output to On.
OUTP ON