Anritsu MS2840A - TRGLVL;TRGLVL?

Chapter
４
Native Device Message Details
4-342
TRGLVL/TRGLVL?
Trigger Level
Function
This command sets the threshold value of the level where trigger sweep
starts.
Command
TRGLVL level
Query
TRGLVL?
Response
level
No suffix code. Refer to the parameters below for numerical values.
Parameter
level
Threshold value of level where trigger sweep
starts
When trigger signal source is video detection (Video) and at log
scale:
Range –150 to +50 dBm
Resolution 1 dB
Suffix code DBM, DM
dBm is used when omitted.
When trigger signal source is video detection (Video) and at linear
scale:
Range 0 to 100%
Resolution 1%
Suffix code None
When trigger signal source is wideband IF detection (Wide IF Video):
Range –60 to 50 dBm
Resolution 1 dB
Suffix code DBM, DM
dBm is used when omitted.
Details
These settings are applied when the trigger signal source is video
detection (Video) or wideband IF detection (Wide IF Video).