Chapter 2 SCPI Device Message Details
2-44
[:SENSe]:FREQuency:STARt <freq>
Start Frequency
Function
This command sets the start frequency.
Command
[:SENSe]:FREQuency:STARt <freq>
Parameter
<freq>
Start frequency
Range
[MS269xA]
–100 MHz to 6.0499997 GHz (MS2690A)
–100 MHz to 13.5999997 GHz (MS2691A)
–100 MHz to 26.5999997 GHz (MS2692A)
[MS2830A]
–100 MHz to 3.6999997 GHz (Option 040)
–100 MHz to 6.0999997 GHz (Option 041)
–100 MHz to 13.5999997 GHz (Option 043)
–100 MHz to 26.5999997 GHz (Option 044)
–100 MHz to 43.0999997 GHz (Option 045)
[MS2840A]
–100 MHz to 3.6999997 GHz (Option 040)
–100 MHz to 6.0999997 GHz (Option 041)
–100 MHz to 26.9999997 GHz (Option 044)
–100 MHz to 44.9999997 GHz (Option 046)
Resolution 1 Hz
Suffix code HZ, KHZ, KZ ,MHZ, MZ, GHZ, GZ
Hz is used when omitted.
Default value 0 Hz
Details
This command is not available during the Spectrum Emission Mask
measurement or the Spurious Emission measurement.
When Internal Signal Generator Control On/Off is On, the start
frequency range depends on the frequency range of Signal Generator.
Example of Use
To set the start frequency to 1 GHz.
FREQ:STAR 1GHZ
To Next Page
Loading...
