Chapter 2 SCPI Device Message Details
2-262
[:SENSe]:SWEep[:TYPE][:AUTO]:RULes?
Auto Sweep Type Select Rules Query
Function
This command queries the rule for switching between sweep and FFT
during measurement.
Query
[:SENSe]:SWEep[:TYPE][:AUTO]:RULes?
Response
<rules>
Parameter
<rules>
Switching rules
DRAN
Selects sweep/FFT prioritizing dynamic range.
SPE
Selects sweep/FFT prioritizing measurement
speed.
OSW
Uses only sweep.
PSW
Prioritizes sweep for selection. Uses FFT only for
RBW that cannot be measured by sweep.
PFFT
Prioritizes FFT for selection. Uses sweep only for
RBW that cannot be measured by FFT.
Details
This command is not available for MS269x Series.
Example of Use
To query the rule for switching between sweep and FFT.
SWE:RUL?
> DRAN
To Next Page
Loading...
