Anritsu MS2840A - :CALCulate:TOI:FREQuency:BASE:UPPer?; [:SENSe]:TOI:FREQuency:BASE[:LOWer[:UPPer]]:AUTO ON|OFF|1|0

Chapter 2 SCPI Device Message Detail
2-830
Example of Use
To query the upper tone frequency.
TOI:FREQ:BASE:UPP?
> 2000000000
Related Command
This command has the same function as the following command.
:CALCulate:TOI:FREQuency:BASE:UPPer?
:CALCulate:TOI:FREQuency:BASE:UPPer?
TOI Upper Tone Frequency Query
Function
This command queries the upper tone frequency for the TOI
measurement.
Refer to
[:SENSe]:TOI:FREQuency:BASE:UPPer <freq>
.
Related Command
This command has the same function as the following command.
[:SENSe]:TOI:FREQuency:BASE:UPPer?
[:SENSe]:TOI:FREQuency:BASE[:LOWer[:UPPer]]:AUTO ON|OFF|1|0
TOI Tone Frequency Auto/Manual
Function
This command turns on and off the automatic setting of the tone
frequency for the TOI measurement.
Command
[:SENSe]:TOI:FREQuency:BASE[:LOWer[:UPPer]]:AUTO <switch>
Parameter
<switch>
Automatic setting of the frequency for the TOI
measurement
ON|1
Turns on the automatic setting of the frequency
for the TOI measurement. (Default)
OFF|0
Turns off the automatic setting of the frequency
for the TOI measurement.