Anritsu MS2840A - GATELVL;GATELVL?

Chapter
４
Native Device Message Details
4-106
GATELVL/GATELVL?
Gate Level
Function
This command sets the threshold value of the level where gate sweep is
started.
Command
GATELVL level
Query
GATELVL?
Response
level
Returns a value in dBm units, without a suffix code.
Parameter
level
Threshold value of level where gate sweep is
started
Range –60 to 50 dBm
Resolution 1 dB
Suffix code DBM, DM
dBm is used when omitted.
Details
This setting is applied when the gate signal source is wideband IF
detection (Wide IF video).
Example of Use
To set the gate sweep start level to –10 dBm.
GATELVL -10
GATELVL?
> -10