Anritsu MS2840A - [:SENSe]:SWEep:EGATe:WIF|:RFBurst:LEVel:ABSolute <ampl>; [:SENSe]:SWEep:EGATe:WIF|:RFBurst:LEVel:ABSolute?

Chapter 2 SCPI Device Message Details
2-296
[:SENSe]:SWEep:EGATe:WIF|:RFBurst:LEVel:ABSolute <ampl>
Gate Level
Function
This command sets the threshold of the level to start the gate sweep.
Command
[:SENSe]:SWEep:EGATe:WIF|:RFBurst:LEVel:ABSolute <ampl>
Parameter
<ampl>
Threshold of level to start gate sweep
Range –60 to 50 dBm
Resolution 1 dB
Suffix code DBM, DM
dBm is used even when omitted.
Details
This setting is enabled when the gate signal source is wideband IF
detection (Wide IF Video).
Example of Use
To set the start level of the gate sweep to
–
10 dBm.
SWE:EGAT:WIF:LEV:ABS -10
[:SENSe]:SWEep:EGATe:WIF|:RFBurst:LEVel:ABSolute?
Gate Level Query
Function
This command queries the threshold of the level to start the gate sweep.
Query
[:SENSe]:SWEep:EGATe:WIF|:RFBurst:LEVel:ABSolute?
Response
<ampl>
Parameter
<ampl>
Threshold of level to start gate sweep
Range –60 to 50 dBm
Resolution 1 dB
Suffix code None. Value is returned in dBm units.