Anritsu MS2840A - SPUR:SWE:POIN;SPUR:SWE:POIN?

Chapter
４
Native Device Message Details
4-294
Example of Use
To configure the setting to pause before sweep of each segment.
SPUR:SWE:PAUS
ON,ON,ON,OFF,OFF,ON,ON,ON,ON,OFF,OFF,ON,ON,ON,ON,OFF,OFF
,ON,ON,ON
SPUR:SWE:PAUS?
> 1,1,1,0,0,1,1,1,1,0,0,1,1,1,1,0,0,1,1,1
SPUR:SWE:POIN/SPUR:SWE:POIN?
Spurious Emission Trace Point
Function
This command sets the number of the points in the trace data of each
segment.
Command
SPUR:SWE:POIN
integer_1,integer_2,integer_3,integer_4,integer_5,intege
r_6,integer_7,integer_8,integer_9,integer_10,integer_11,
integer_12,integer_13,integer_14,integer_15,integer_16,i
nteger_17,integer_18,integer_19,integer_20
Query
SPUR:SWE:POIN?
Response
integer_1,integer_2,integer_3,integer_4,integer_5,intege
r_6,integer_7,integer_8,integer_9,integer_10,integer_11,
integer_12,integer_13,integer_14,integer_15,integer_16,i
nteger_17,integer_18,integer_19,integer_20
Parameter
integer_n
Number of points in trace data of Segment n
11
11 points
21
21 points
41
41 points
51
51 points
101
101 points
201
201 points
251
251 points
401
401 points
501
501 points